jcb 214e Service Manual page 667

Backhoe loader
Hide thumbs Also See for 214e:
Table of Contents

Advertisement

www.WorkshopManuals.co.uk
Section F
80 - 2
Removal and Replacement (cont'd)
Note: The following procedure can be applied to both AWS
and 2WS machines. Dis-regard information not applicable to
your machine type, for instance, 2 wheel steer machines will
not have steering proximity switches fitted.
! WARNING
A raised and badly supported machine can fall on you.
Position the machine on a firm, level surface before
raising one end. Ensure the other end is securely
chocked. Do not rely solely on the machine hydraulics or
jacks to support the machine when working under it.
Disconnect the battery, to prevent the engine being
started while you are beneath the machine.
GEN 1-1
Removal
! WARNING
Raised loader arms can drop suddenly and cause
serious injury. Before working under raised loader arms,
fit the loader arm safety strut.
GEN 3-2
1
Release screws J and remove the front grille.
2
Remove the cover K from the proximity switch and then
remove the bracket and switch assembly.
3
Using tool 892/00822 remove bolts A to disconnect the
drive shaft from the axle.
4
Disconnect the hydraulic pipes B from the steer rams,
blank off all exposed connections.
5
Disconnect remote grease nipple hose H.
6
Loosen the road wheel retaining nuts D.
7
Make sure that the rear wheels are blocked, use the
loader arms to raise the front end of the machine.
Prop the machine on each side as shown at C.
8
9
Remove the front road wheels.
10
Position a jack underneath the balance point (see Note)
of the axle and support the axle weight.
Note: Because the drivehead assembly is offset, the balance
point of the axle is not the centre of the axle. Attach a
'cradle' to the jack that will partially embrace the axle.
11
Remove nut E and pivot pin retaining bolt F.
12
Remove pivot pin G seals, use puller (tool no.
993/68100) and remove the pivot pin G and axle shims.
13
Lower the jack so that the axle is clear of the mounting
yoke and remove the axle.
9803/3280
Transmission
Front Axle - SD55, SD70
Purchased from www.WorkshopManuals.co.uk
Section F
80 - 2
Issue 1

Advertisement

Table of Contents
loading

This manual is also suitable for:

4cx3cx214215217

Table of Contents