Table of Contents
Advertisement
www.WorkshopManuals.co.uk
Section F
81 - 10
Hub and Driveshaft - Assembly (cont'd)
20
Fit the planet carrier onto the bearing carrier, ensuring
that the two tapped holes are in line with those on the
bearing carrier. Fit and torque tighten screws A to
56Nm (41Ibf ft; 5.7kgf m) after applying JCB Lock and
Seal to the threads.
Note: Do not strike the centre of the planet gear carrier when
fitting as this may dislodge the driveshaft thrust pad fitted at
step 17.
Re-fill hubs with the correct grade oil.
9803/3280
Transmission
Front Axle - SD55, SD70
Purchased from www.WorkshopManuals.co.uk
Section F
81 - 10
A
S258220
Issue 1
Advertisement
Table of Contents
