Table of Contents
Advertisement
www.WorkshopManuals.co.uk
Section F
127 - 10
Assembly (cont'd)
10
Fit the Torque Converter Housing - Gearboxes with
18 bolt fix only
Important Note: Only the specified sealant can be used. The
*
machine MUST NOT be operated for at least 6 hours after
sealant has been applied and the converter housing
assembled. This is to allow time for the sealant to cure.
a
Make sure that the front case and torque converter
housing (10a) mating faces are clean, dry and
undamaged. Apply a 3 mm wide bead of Bondloc B574
sealant to the front casing as shown at A (pump not
shown for clarity). Make sure that sealant is applied
between all the port channels as shown. Take extra
special care in the area X as sealing is critical in these
areas. Be sure not to block galleries with sealant. Fit a
new 'O' ring 10d to the housing 10a.
b
Carefully locate the torque converter casing on the front
case. Fit new 10.9 grade bolts as follows:
M10 bolts 10b (15 off). Note that spacers are fitted
under bolts at positions 10 and 14.
M8 bolts 10c. (3 off)
Progressively torque tighten the bolts in the sequence
shown. Note that the bolt at position 1 is re-torqued
after tightening the bolt at position 15.
Sequence
Bolt Position
(shown at B)
1 - 9
1 - 9
10
10
11 - 13
11 - 13
14
14
15
15
16
1 (Re-torque)
17 - 19
17 - 19
9803/3280
Transmission
Powershift Gearbox
Torque
Nm
lbf ft
78
57.5
60
44.25
78
57.5
60
44.25
78
57.5
78
57.5
38
28
Purchased from www.WorkshopManuals.co.uk
10c
10c
10a
10c
10d
Section F
127 - 10
10b
A401250
Issue 3*
Advertisement
Table of Contents
