Table of Contents
Advertisement
www.WorkshopManuals.co.uk
Section B
20 - 4
Electronic Vacuum Gauge
The CPS VG100 vacuum gauge is an electronic type using
LED's to indicate various states of vacuum. It is used in
place of or to supplement the gauge on the vacuum pump.
Before connecting into the system switch on to check that
the first LED lights to show that the battery is in good
condition.
Note: The indicator lights show pressure in inches of
mercury (Hg) and vacuum in microns (0.001mm Hg).
ATM/BAT
Normal atmospheric pressure reading.
Battery condition.
15''/510mbar
381mm (15 in)Hg. Partial vacuum -
Vacuum system is operating.
29''/980mbar
736mm (29 in)Hg. No vacuum drawn -
Possible system leakage.
8000µ
8.0mm (0.31 in)Hg. Partial vacuum -
If the reading does not progress the
system may have a slow leak.
1000µ
1.0mm (0.039 in)Hg. Deeper vacuum.
600µ
0.6mm (0.023 in)Hg. Deep vacuum.
400µ
0.4mm (0.015 in)Hg. Deep vacuum.
200µ
0.2mm (0.0078 in)Hg. Deep vacuum.
25µ
0.025mm (0.00098 in)Hg. Pump Test.
Maximum sustainable vacuum.
9803/3280
Body & Framework
Service Procedures
A396790
Purchased from www.WorkshopManuals.co.uk
Section B
20 - 4
Issue 1
Advertisement
Table of Contents
