Table of Contents
Advertisement
www.WorkshopManuals.co.uk
Section E
76 - 2
Removal and Replacement
- Loader Shovel Ram
Removal
! WARNING
The loader arm interlevers are potentially dangerous,
when pivoting about their centre they form a 'scissor'
point with the loader arm. Make sure the interlevers are
securely blocked when working in the loader arm area.
BF 2-1
1
Park the machine on firm level ground. Engage the
parking brake and set the transmission to neutral.
Rest the shovel flat on the ground.
2
DANGER
Hydraulic Pressure
Hydraulic fluid at system pressure can injure you. Before
disconnecting or connecting hydraulic hoses, stop the
engine and operate the controls to release pressure
trapped in the hoses. Make sure the engine cannot be
started while the hoses are open.
INT-3-1-11/1
3
Switch off the engine and vent residual hydraulic
pressure from the loader end by operating the loader
controls back and forth several times.
4
Label and then remove the shovel ram hoses A. Plug
and cap all open orifices to prevent loss of fluid and
ingress of dirt.
! CAUTION
This component is heavy. Do not attempt to remove it
unless its weight is held by a sling. Make sure that the
sling is attached to a suitable lifting appliance.
HYD 2-3/1
5
Fasten lifting straps to the shovel ram, make sure that
the weight of the ram is supported by the sling.
6
Remove kliprings B, shims C and spacers D.
7
Remove pivot pins E.
9803/3280
Hydraulics
Hydraulic Rams
Purchased from www.WorkshopManuals.co.uk
Replacement
Replacement is a reversal of the removal sequence.
! WARNING
Fine je t s of hydra ulic fluid a t high pre ssure c a n
penetrate the skin. Do not use your fingers to check for
hydraulic fluid leaks. Do not put your face close to
suspected leaks. Hold a piece of cardboard close to
suspected leaks and then inspect the cardboard for
signs of hydraulic fluid. If hydraulic fluid penetrates your
skin, get medical help immediately.
INT-3-1-10/1
Coat pivot pins with anti-rust lubricant.
All klipring intallations to have a maximum end float of 2mm
(0.080in.)
Make sure that each klipring is installed with a shim.
Section E
76 - 2
Issue 1
Advertisement
Table of Contents
