Engine Panels; Opening And Closing The Bonnet; Removing And Fitting A Side Panel - jcb 214e Service Manual

www.WorkshopManuals.co.uk
Section 3
7 - 1

Opening and Closing the Bonnet

To release the bonnet, pull handle A, the bonnet will
automatically open and be supported on gas struts.
To close the bonnet, push the bonnet down, make sure it is
locked in place and the side panels are located correctly.
A
399110
9803/3280
Routine Maintenance

Engine Panels

Purchased from www.WorkshopManuals.co.uk

Removing and Fitting a Side Panel

! WARNING
The loader arms must be raised and locked before you
remove an engine side panel. Keep the arms locked up
until the side panel is put back. If you do not lock the
loader arms, the shovel can fall and you could be
crushed. See Loader Arm Safety Strut in MAINTENANCE
section.
2-3-1-4/1
! WARNING
Do not remove the engine side panel while the engine is
running.
2-3-1-5
Raise the loader arms and fit the safety strut, see
1
Loader Arms Safety Strut.
Stop the engine, and remove the starter key.
2
3 Open the bonnet.
4 Remove the side panel B, lift the side upwards and
outwards.
5 Fit the side panel, carefully slot the side panel into
position. Lower and lock the bonnet.
Section 3
7 - 1
B
399380
Issue 1