Table of Contents
Advertisement
www.WorkshopManuals.co.uk
Section F
81 - 6
Hub and Driveshaft - Assembly
1
Tap drive shaft inner bearing into position and secure
with circlip K.
Fit new oil seal J. Pack grease between lips of seal.
2
3
Fit drive shaft, taking care to locate inner end into
splines of differential gears.
4
Press new trunnion oil seal into position followed by the
bearing. Grease bearing and oil seal before fitting to
axle.
5
Fit driveshaft needle roller bearing to the hub carrier.
Pack the cavity between the oil seal lips with grease
and then fit the seal.
9803/3280
Transmission
Front Axle - SD55, SD70
Purchased from www.WorkshopManuals.co.uk
K
J
Section F
81 - 6
255990
S258270
S161460
Issue 1
Advertisement
Table of Contents
