Hydraulic Speed Control (Hsc) - jcb 214e Service Manual

www.WorkshopManuals.co.uk
Section E
23 - 3
Loader Valve - Pressure Testing

Hydraulic Speed Control (HSC)

The following procedure can be used to establish if the
hydraulic speed control facility is working correctly.
Make sure that the hydraulic oil is at working temperature,
i.e. 50° C (122° F).
Lower the backhoe bucket and loader shovel to rest on the
ground; stop the engine; operate the control levers to vent
residual hydraulic pressure.
1 Connect a 0 - 400 bar (0 - 6000 lbf/in
to pressure test connector A.
2 With the engine running at 1500 revs/min, slowly
operate arms raise,
approximately 138 bar (2000 lbf/in
3 Make sure that the HSC rocker switch (mounted on the
console) is in the OFF position. Raise the arms slowly,
select the rocker switch to ON, the arms should raise
quicker.
4 Make sure that the HSC rocker switch (mounted on the
console) is in the OFF position. Raise the arms slowly,
press the button on the loader control knob, the arms
should raise quicker.
If the loader arms fail to respond, then check the HSC
5
hydraulic and electrical circuits for any faults.
9803/3280
Hydraulics
Service Procedures
2
) pressure gauge
the pressure should
2
).
Purchased from www.WorkshopManuals.co.uk
be
A
Section E
23 - 3
352710
Issue 1