Air Conditioning Maintenance; Adjusting The Compressor Drive Belt - jcb 214e Service Manual

www.WorkshopManuals.co.uk
Section 3
26 - 1
! WARNING
The air conditioning system is a closed loop system and
contains pressurised refrigerant. No part of the system
should be disconnected until the system has been
discharged by a refrigeration engineer or a suitably
trained person. You can be severely frostbitten or injured
by escaping refrigerant.
4-3-4-1/2

Adjusting the Compressor Drive Belt

! WARNING
Make sure the engine cannot be started. Disconnect the
battery before doing this job.
2-3-3-5
Park the machine on firm level ground, engage the
1
parking brake and set the transmission to neutral. Raise
and block the loader arms. Lower the backhoe to the
ground and stop the engine.
2 Loosen bolts A, B and C. Position the compressor so
that there is 10 mm (3/8 in) slack at point X.
3 Tighten bolt A, then bolts B and C.
9803/3280
Routine Maintenance
Air Conditioning (if fitted)
Purchased from www.WorkshopManuals.co.uk
X
B
A
Section 3
26 - 1
C
S209393
Issue 1