Switching On The Drystar 5300 - AGFA Drystar 5300 Reference Manual

Switching on the Drystar 5300

" Before switching on the Drystar 5300, read the safety instructions. Refer
to 'Safety precautions'
Follow the procedure below to ensure proper startup of the Drystar 5300 and
to check that everything is working correctly.
1
Check that the power cord is plugged in and then switch on the printer by
pressing the Power/Reset button.
On the display, the following message is displayed. After a short while, a progress
indicator will show the proceeding of the self-test.
Please WAIT
Self-test
proceeding
•
If anything goes wrong during the self-test, refer to
2
The printer is ready for operation:
•
If, on the front panel display, the READY message is shown, the status indicator
LED is constantly green.
READY
" It takes 13 minutes (starting up of the Drystar 5300 and heating up of the
thermal print head) before you can start printing. The display will inform
you that the printer is warming up:
WARMING UP
Please wait
28
on page 8.
62%
'Startup errors' on page 185.
2920B EN 20031206