AGFA Drystar 5300 Reference Manual page 38

5
The printer is ready to receive a new film when the following message
appears:
- Remove cover sheet
from tray
- Load new film
- Close tray
6
Remove the white (protective) film sheet.
7
Take film pack and slide it into the input tray.
" Do not slide the film pack completely into the input tray, otherwise you
cannot reach the sticker anymore.
" Verify that the film type on the film pack corresponds with the sticker on
the tray! If you use another film type, you are advised to change the
labels (inside and outside) on the tray.
38
2920B EN 20031206