Installation Operations - AGFA Drystar 5300 Reference Manual

Installation operations

Two installation operations are possible:
•
install new software, or upgrade existing software on the internal CF-card:
•
'Software installation from an external CF-card'
•
'Software installation from the previous version on the internal CF-card'
(page 125),
•
perform a complete installation procedure, using the printer installation wizard.
Upgrading the software
It is possible to install new software or new software components onto the
internal CF-card.
Different software (components) can be installed:
•
language files,
•
modality specific files,
•
output LUT,
•
calibration files,
•
...
The new software will be activated after the installation procedure (this may
require a reset operation). The previously installed software components will
be automatically removed when installing new software or new data. A copy
of the previous configuration is saved (as a dataset) on the internal CF-card.
1
Press the Key-operator key to enter the key-operator mode.
2
On the key-operator main menu, press the Down key eight times, followed by
the Confirm key to select 'Installation'.
The 'Installation' screen will be displayed:
1 Software
Installation
2 Printer
installation
3
Press the Confirm key to select 'Software Installation'.
122
IN
(page 123),
2920B EN 20031206