Using the installation wizard
When you install the Drystar 5300, the installation wizard will guide you
through the complete installation procedure.
The installation wizard consists of three steps:
•
'Entering the printer network settings'
•
'Entering modality specific settings'
•
'Saving the configuration'
When you have entered the required data, the installation is complete.
" Although the installation wizard consists of three separate steps, these
steps cannot be performed separately.
" To change the settings once the installation is completed, refer to
'Changing the configuration settings'
Starting the installation wizard
1
Press the Key-operator key to enter the key-operator mode.
2
On the key-operator main menu, press the Down key eight times, followed by
the Confirm key to select 'Installation'.
The 'Installation' screen will be displayed:
1 Software
Installation
2 Printer
installation
3
Press the down key, followed by the Confirm key to select 'Printer
installation'.
126
(page 137).
IN
(page 129),
(page 133),
on page 58.
2920B EN 20031206