AGFA Drystar 5300 Reference Manual page 85

Changing general image quality settings
1
Perform steps 1 and 2 of the
procedure on page 59.
2
On the 'Change settings' screen, press the Down key three times, followed by
the Confirm key to select 'Image quality'.
The following screen will appear:
1 General setting
2 Def. densitometer
3 Modality16char
4 Modality16char
5 etc...
3
Press the Confirm key to select 'General setting'.
The 'General setting' screen is displayed:
Select default
film calibration
* ON
OFF
This setting is by default set to ON and will apply to every modality. The currently
active setting is indicated with a '*'.
" For more information on film calibration settings: refer to
the calibration policy'
4
Press the up/down key to select the film calibration default.
When the setting is ON, the Drystar 5300 will ask you to enter the calibration
frequency:
Select Frequency
Every 01 film packs
Enter the calibration frequency by means of the up/down key. Refer to
on page 27.
5
Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
2920B EN 20031206
CS
CS
on page 102.
CS
'Accessing the Change settings menu'
'Understanding
'Data entry'
85