Changing The Film Type - AGFA Drystar 5300 Reference Manual

Changing the film type

Using the following procedure you can overrule the film type which is
automatically read by means of the Film Identification tag on the film pack.
This procedure is only to be used exceptionally when the Film
Identification tag info is incorrect.
1
Perform steps 1 and 2 of the
procedure on page 59.
2
On the Change settings menu, press the Down key, followed by the Confirm
key to select 'Input tray'.
The 'Input tray' screen is displayed:
1 Film view
2 Film type
3 Film format
3
Press the Down key, followed by the Confirm key to select 'Film type'.
The 'Film type' screen is displayed:
1*Drystar DT2B
2 Drystar DT2C
OVERRULE to RF-tag
The film type read by the Film Identification tag is marked with a '*'.
" You can find the film type on the film packaging, e.g. 'DRYSTAR DT2C'.
" The message 'OVERRULE to RF-tag' is only visible if the film type,
specified by the Film Identification tag, has been overruled.
4
Press the up/down arrow keys to select the film type.
5
Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
" The overrule settings remain active until a new film pack is loaded.
66
CS
CS
Flashing
'Accessing the Change settings menu'
2920B EN 20031206