AGFA Drystar 5300 Reference Manual page 183

If the film pack is inserted correctly and the Drystar 5300 does not resume printing,
the following message will appear:
No Identification
code detected for
current film pack
Remove and re-insert
film pack -including
protective sheet-
properly. Follow
loading instructions
2
To continue with the current (not identified) film pack, press the Continue
button.
The following message is displayed:
No Identification
code detected or
Read error in tray.
Please insert
correct film pack or
Call Service.
Code Exxxxx
$ If you wish, you can try again to re-insert the current or an other film pack.
Open the input tray to initiate the loading sequence. If you re-insert a film
pack, the Drystar 5300 will perform the check-sequence.
3
Press the Confirm button.
If the "Overrule RF-tag Reading" Setting is active, the following message is
displayed:
Overrule of
identification code
is active.
MaxD is limited due
to safety reasons.
" If the "Overrule RF-tag Reading" Setting is not activated, the following
message will be displayed:
No Identification
code detected.
Printing is disabled
Re-enable printing
by inserting correct
film media pack
" In this case, press the Confirm key to initiate the loading procedure again
or call your local service organization to enable the "Overrule RF-tag
Reading" Setting.
2920B EN 20031206
183