AGFA Drystar 5300 Reference Manual page 46

Accessing the key-operator menus
•
The key-operator mode functions (i.e. the main menu level) can be accessed by
pressing the Key-operator key on the front panel.
After pressing the Key-operator key the main menu is displayed:
" The two characters displayed in inverse video in the upper right corner
indicate the current menu item (e.g. 'KO' for main Key-operator menu,
'QC' for Quality Control, etc.).
1 Show settings
2 Change settings
3 Print image
4 Save configuration
5 Restore config.
6 Calibration
7 Service actions
8 Quality Control
9 Installation
" When you enter the key-operator mode while the Drystar 5300 is printing,
it will first finish the active print job(s):
Stopping printing
process before
entering key-op mode
Please wait.
" If certain mandatory site specific data has not yet been entered, the
following screen is displayed when entering the key-operator mode (refer
to 'Changing the site specific data (via remote browser only)'
page 64):
Please provide site
specific information
via remote
connection (browser)
46
KO
KO
on
2920B EN 20031206