AGFA Drystar 5300 Reference Manual page 123

" Before the procedure starts, the system suggests you make a backup
copy of the current configuration. It is highly recommended to do this, so
you can always restore it in case something should go wrong.
The following screen is displayed:
Before install
please make backup
1 OK, make backup
2 Skip backup
If you want to backup the current configuration on an external CF-card, press the
Confirm key (OK). The printer will perform the
page 95. Note: the complete configuration is saved!).
If you do not want to backup the current configuration, press the Escape key (Skip).
4
After the backup is finished (or if you have chosen to skip the backup), the
system will proceed with the actual upgrade.
The 'Software Installation' screen will be displayed:
SW Installation
from:
External CF-card
Previous SW version
Software installation from an external CF-card
5
Press the Confirm key to select 'External CF-card'.
The 'Installation from CF-card' screen is displayed:
Installation
from CF-card
Insert CF-card
6
Insert the CF-card.
" Refer to
'Inserting a CF-card'
" If a wrong CF-card has been inserted, the following message is
displayed:
Installation
from CF-card
Wrong card inserted
7
If there are multiple dataset files present on the CF-card, a list is shown.
2920B EN 20031206
IN
IN
IN
on page 21.
IN
'Save configuration procedure' (See
123