AGFA Drystar 5300 Reference Manual page 27

Key-operator mode
In key-operator mode, operation is menu driven. The menu displays the
key-operator functions.
1 Show settings
2 Change settings
3 Print image
4 Save configuration
5 Restore config.
6 Calibration
7 Service actions
8 Quality control
9 Installation
The display shows only four lines. In the above figure, they are indicated in
the grey zone. The other possible lines are shown in the white area, and can
be reached by scrolling using the Up/Down arrow keys on the Keypad.
The active keys are indicated by their respective LEDs.
Data entry
When entering numerical or alphanumerical data, always adhere to the
following principles:
•
Only (alpha)numerical data can be entered.
•
During data entry, the field is displayed in reverse mode.
•
Increment the number in a(n) (alpha)numerical entry field by pressing the Up
key. Transition from 9 to 0 of one figure will also increment the next figure to the
left, respecting the valid limits of the range.
•
Decrement the number in a(n) (alpha)numerical entry field by pressing the Down
key. Transition from 0 to 9 of one figure will also decrement the next figure to the
left, respecting the valid limits of the range.
•
Move the entry position in a(n) (alpha)numerical entry field from right to left by
pressing the Left key.
•
Move the entry position in a(n) (alpha)numerical entry field from left to right by
pressing the Right key.
•
Press and hold down a key to repeat arrow key actions.
•
To accept an entry in a menu, press the Confirm key.
•
A short beep acknowledges and terminates the entry.
•
The Drystar 5300 will sound a long beep if you press a key that is not to be used
at that moment.
2920B EN 20031206
KO
Visible
Reachable with Up/Down arrow keys
27