AGFA Drystar 5300 Reference Manual page 86

Changing the default densitometer
1
Perform steps 1 and 2 of the
procedure on page 59.
2
On the 'Change settings' screen, press the Down key three times, followed by
the Confirm key to select 'Image quality'.
The following screen will appear:
1 General setting
2 Def. densitometer
3 Modality16char
4 Modality16char
5 etc...
3
Press the
'Def. densitometer'.
The 'Select default densitometer' screen is displayed:
Select default
densitometer:
1 * MacBeth TR924
2 X-Rite 310
3 X-Rite 331
4 X-Rite 341
5 X-Rite 301
The current default densitometer is indicated with a '*'.
4
Press the up/down key to select the default densitometer.
" All densities that are shown on the Drystar 5300 screens are according to
the response of the default densitometer. Refer also to
of Drystar media'
5
Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
86
CS
Down key, followed
CS
on page 106.
'Accessing the Change settings menu'
by the Confirm key to select
'Density response
2920B EN 20031206