AGFA Drystar 5300 Reference Manual page 59

Image quality
'Changing general image quality settings'
'Changing the default densitometer'
'Changing Image quality settings for a modality'
Accessing the Change settings menu
" Before you can change the settings, the 'Printer installation wizard'
should be executed. If the printer has not been installed yet, the following
screen is displayed:
Settings can only
be changed after
Printer installation
Proceed as follows to access the 'Change settings' menu:
1
Press the Key-operator key to enter the key-operator mode.
2
On the key-operator main menu, press the Down key, followed by the
Confirm key to select 'Change settings'.
The 'Change settings' screen is displayed:
1 General
2 Input tray
3 Network (DICOM)
4 Image quality
" This menu is the starting point for changing the Drystar 5300 settings
(see below).
3
Press the Escape key to return to the key-operator main menu.
4
Press the Escape key to quit the key-operator mode.
When the printer settings have been changed, the 'Accept changes' window
is displayed:
Accept changes
YES (v) NO (x)
Press the Confirm key (YES) if you wish to accept the changed settings.
Press the Escape key (NO) if you want to quit the procedure without any changes.
2920B EN 20031206
CS
CS
CS
85
86
87
59