Input Power; General Cleaning - GE LOGIQ 5 PRO Service Manual

GE M S
EDICAL YSTEMS
D 2380207, R
IRECTION EVISION
10-5-2-2 Peripheral/Option Checks
If any peripherals or options are not part of the system configuration, the check can be omitted. Refer
to the User Manual for a list of approved peripherals/options.
Table 10-6
Step
1
2 B/W Printer Verify hardcopy output of the B/W video page printer. Clean heads and covers if necessary.
3 Color Printer Verify hardcopy output of the Color video page printer. Clean heads and covers if necessary.
4
5 InSite/iLinq
6 Camera
7 Footswitch
8
10-5-3

Input Power

10-5-3-1 Mains Cable Inspection
Table 10-7
Step
1 Unplug Cord Disconnect the mains cable from the wall and system.
2
3
4
10-5-4 Cleaning
10-5-4-1

General Cleaning

Table 10-8
Step
1 Console
2 Probe Holder Clean probe holders (they may need to be soaked to remove excess gel).
7
GE Approved Peripheral/Hardware Option Functional Checks
Item
VCR
Verify record/playback capabilities of the VCR. Clean heads and covers if necessary.
DICOM
Verify that DICOM is functioning properly. Send an image to a DICOM device.
Verify that InSite is functioning properly. Ensure two-way remote communications.
(Warranty & Contract Customers only)
Verify hardcopy output of the film camera. Clean as necessary.
Verify that the footswitch is functioning as programed. Clean as necessary.
ECG
Verify basic operation with customer
Mains Cable Inspection
Item
Inspect
Inspect it and its connectors for damage of any kind.
Verify that the LINE, NEUTRAL and GROUND wires are properly attached to the terminals, and that no
Verify
strands may cause a short circuit.
Verify
Inlet connector retainer is functional.
General Cleaning
Item
Use a fluid detergent in warm water on a soft, damp cloth to carefully wipe the entire system. Be careful
not to get the cloth too wet so that moisture does not enter the console.
Chapter 10 Care & Maintenance
LOGIQ™5 PRO S
Description
Description
Description
M
ERVICE ANUAL
10-7