Op Panel A/N Keyboard Assy (Fru No. 207) - GE LOGIQ 5 PRO Service Manual

GE M S
EDICAL YSTEMS
D 2380207, R
IRECTION EVISION
8-4-8

OP Panel A/N Keyboard Assy (FRU No. 207)

Purpose: This is a description on how to remove and replace OP Panel A/N Keyboard Assy.
8-4-8-1 Tools
• Common pillips screwdrivers.
8-4-8-2 Needed Manpower
• 1persons, 5 minutes + travel
8-4-8-3 Preparations
• Shut Down the System and switch off the Main Breaker at the rear as described in section 4-3-2 on
page 4.
• Keyboard Assy should be removed before proceed. For more information, refer to section 8-4-1 on
page 16.
8-4-8-4 Removal Procedure
1.) Unscrew five (5) screws and remove the HUB Assy EMC guard. Refer to Figure 8-30.
2.) Disconnect two(2) connectors (1-2) from the HUB Board. Refer to Figure 8-31.
8 - 30
7
1
2
Figure 8-30 Removing HUB EMC guard
1
Figure 8-31 Disconnecting 2 connectors
Section 8-4 - Keyboard Block
EMC Guard
LOGIQ™ 5 PRO S
ERVICE
5
3
4
2
M
ANUAL