Tgc Knob Set (Fru No. 206) - GE LOGIQ 5 PRO Service Manual

GE M S
EDICAL YSTEMS
D 2380207, R
IRECTION EVISION
8-4-7

TGC Knob Set (FRU No. 206)

Purpose: This is a description on how to remove and replace TGC Knobs.
8-4-7-1 Tools
• Common pillips screwdrivers.
8-4-7-2 Needed Manpower
• 1persons, 5 minutes + travel
8-4-7-3 Preparations
• Shut Down the System and switch off the Main Breaker at the rear as described in section 4-3-2 on
page 4.
8-4-7-4 Removal Procedure
1.) Remove eight (8) TGC knobs from the upper side of the Keyboard. Refer to Figure 8-29.
2.) Perform the following functional tests. If all are successful, include the debrief script provided below.
Table 8-14
Service Manual
Section 4-3-1
Section 4-3-2
Section 4-11-4
8-4-7-5 Mounting Procedure
Install the new parts in the reverse order of removal.
7
Figure 8-29 Removing TGC Knobs
Functional Tests
Section Functional Test / Diagnostic Test
Chapter 8 Replacement Procedures
Power On/Boot Up
Power Off / Shutdown
TGC Knob Set validation
LOGIQ™ 5 PRO S
ERVICE
Debrief Script
"Service Manual, Direction
2380207
, Rev 7+, Section 8-4-7. Equipment
passed all required tests and is ready for use. "
M
ANUAL
8 - 29