Aes Configuration Using Acli - Avaya 3500 Series Getting Started

Configuring the switch using ACLI
Displaying AAUR configuration
Use this procedure to view the AAUR configuration.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command:
show stack auto-unit-replacement-image enable
Example
The following figure provides a sample of the show stack auto-unit-replacement-image
command.
switch(config)#show stack auto-unit-replacement-image
Auto Unit Image Replacement:

AES configuration using ACLI

You can use Avaya Energy Saver (AES) to configure the switch to utilize energy more efficiently.
Configuring global AES using ACLI
Use the following procedure to enable or disable the energy saving feature for the switch.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Configure global AES:
[no] [default] energy-saver [enable] [efficiency-mode] [poe-power-
saving]
Variable definitions
The following table defines optional parameters that you can enter with the [no] [default]
energy-saver [enable] [efficiency-mode] [poe-power-saving] command.
Variable
[default]
efficiency-mode
Getting Started with Avaya ERS 3500 Series
84
Enabled
Value
Configures AES efficiency mode, POE power saving,
or global AES to default values (disabled).
Enables AES efficiency mode.
Comments on this document? infodev@avaya.com
Table continues...
July 2015