Loss of Administrator password
When the password for the Administrator account is lost, the only method of recovery is to
reset the system to factory defaults, and use the default username (admin) and password
(setup).
For information on resetting the system to factory defaults, see
from the boot menu
Rebooting the Secure Router 2330/4134
This procedure describes the steps necessary to reboot the router.
Procedure steps
Enter the command to reboot the router.
reboot
This command is issued from the CLI root.
Obtaining Configuration Mode access when occupied by an
inactive or unresponsive session
This section describes steps used if an administrator level user needs to gain access to
Configuration Mode in the Secure Router 2330/4134, but is unable to due to an inactive or
unresponsive session.
An inactive session would be classified as a session where a user has failed to issue the exit
command to properly end their console session. Failing to do so leaves Configuration Mode
occupied for a short period of time.
An unresponsive session would be classified as a session where the router has entered a
"hung" state and the user is unable to issue any further commands.
Clearing an inactive session
This procedure describes the steps to clear an inactive session.
Troubleshooting
on page 49.
Important:
Rebooting the Secure Router 2330/4134
Resetting to factory defaults
August 2013
21