Program Mode Entry - Vodavi Starplus DHS Technical Manual

6-2

Program Mode Entry

To make changes in the customer database, you must enter Database Programming from
an idle Executive (display model) Key Telephone. (Any Executive Key Telephone
connected to any station port will serve as the programming entry terminal). Depending
on initial setup, the system may operate only as a Key system and utilize the Key system
(KF) FCC Registration Number, or as a hybrid PBX system which requires a different
unique FCC (MF) Registration Number. The selection of KEY or PBX operation is made by
the installing company and requires proper notification to the Telephone Company
regarding the type of service to be provided by the local exchange carrier.
To enter the programming mode:
1. From an idle station, press the [FEAT] button. The display changes as seen below:
2. Dial [#] + [✳] on the keypad. The display prompts for the database password. The
default password is 000000.
3. Press the center Soft button corresponding to the [show] seen on the display. The
display shows the first customer database-programming category System Type.
There are two choices in this category, PBX or KEY.
Press the right Soft Button [chg]. The value stored for the System Type is changed from
one of the available choices to the other with each depression.
At the moment the [chg] button is pressed and the value displayed, that operation
becomes functional. This is true for any database field where the [chg] button selects
from the available data field values. In other areas of programming where data is entered
from the dial key pad, the [save] Soft Button must be pressed to save that entered data.
F
DB PSW D : _ _
bk sp s how
The FCC Registration number that is provided to the telephone operating company
servicing this equipment is directly related to the programming of this category
Chapter 1, Introduction
(Refer to
S YST EM T YPE :
ba ck nex t
S YST EM T YPE :
ba ck nex t
chg
).
PBX
chg
KEY
chg
Program Mode Entry