Table of Contents
Advertisement
Pause
Pause
Description
You can insert a pause to generate an intentional delay in dialing on outgoing CO line
calls. A pause or a combination of pauses may be stored in the Speed Dial bins to allow
timed access to special services, while allowing you to monitor the progress of the call. A
pause will appear as P on an Executive Telephone display. Last Number Redial will
remember any pauses dialed manually.
Operation
1. During dialing on any CO line or when programming a Speed Dial bin (refer to
Dialing), press [FEAT].
2. Dial [7] + [0]
.
PBX Compatibility
Description
Any CO line in the system may be programmed as a PBX type facility. Station users may
use that PBX facility via a CO line button. To make a PBX call, that CO line button is
accessed and the PBX station number is dialed. To use the PBX facility to make an
outgoing call, the PBX trunk code must be dialed to receive outside Central Office dial
tone. This code may be programmed into the system as a PBX trunk access code. Once
programmed, the system will identify these codes when dialed and adjust feature
operation accordingly.
Operation
CO Line x is connected to a PBX for PBX feature access. The PBX uses the code 9 to access
a PBX trunk for out call dialing. (Code 9 has been programmed into the DHS as the PBX
CODE for trunk access.)
1. When CO line x is accessed, PBX dial tone is heard.
P
Pause may be stored on a programmable feature button and is also used in programming
fields that accept a Pause character.
4-81
Speed
Advertisement
Table of Contents
