Table of Contents
Advertisement
3-16
Six conductor modular jack assemblies for all station instruments (recommended).
Standard punch-down terminal block(s), 66M1-50 type, as required.
Industry-standard, 25-pair cable(s) with a 50-pin male amphenol/AMP type
connector for connection from each equipped 3 x 8 module to the MDF.
AC voltage surge/spike protector.
Standard telephone hand tools and mounting hardware for the KSU, MDF backboard,
punch-down terminal block(s), modular jack assemblies for CO lines, etc.
Some additional tools suggested to have on-hand when installing the
include:
1 box 4 pairCat3 orCat5 twisted pair
25 pair Amp cables (male-female)
25 pair Cat3 cable
89B-Brackets
B splice connectors or Scothlok
splicing connectors
Bridge clips
Butt set (T.S. if possible)
Chain for fishing walls
Computer with RS232
Cordless drill
Diagonal wire cutters
Digit grabber
Drill
Verify On-Site Equipment
Once the equipment installation site is identified and a dedicated AC outlet, earth
ground, adequate lighting and ventilation are available, verify that all equipment
required is on-site and was not damaged during shipping:
Unpacking the KSU - The Key Service Unit is shipped in its own protective carton and
contains the following:
Basic KSU
One mounting template
One System Installation & Maintenance Manual
Open the carton and verify that all items are complete and undamaged. Remove all
packing material and store for future use in the event that return shipment is
required. This should be performed at the installer's office with a 48-hour burn-in
period prior to installation.
Drywall screws
Electrical tape
Extension cord (three-
prong with ground)
Fiber rod for fishing walls
TM
Fish tape
Harmonica adapter
In-line adapter
Ladder
Level
Linesmen scissors
Long nose pliers
M1-66 split blocks
Modular crimping tool
(RJ-11 and RJ-45)
DHS-E Installation
DHS-E
system
Multi-meter (fluke)
Permanent marker (0.8 mm,
0.5 mm for certain
applications)
Phillips head screwdrivers:
#1 x 4
#2 x 4
#2 x 6
Phone jacks
Punch Down Tool (110 and
66 Block Blades)
RJ11 plugs
RJ45 plugs
Standard screwdrivers:
1/8 x 4 in.
1/4 x 4 in.
3/16 x 6 in.
5/32 x 4 in.
Static/Ground Strap
Toner
Wand (Induction Amp)
Wire spools
Yellow 77 (lubricant for wire)
Advertisement
Table of Contents
