Table of Contents
Advertisement
General Conventions
General Conventions
Press the [CLEAR] button to cancel the current operation.
The [FEAT] button joined with dial key codes will appear throughout the text. This
button is used to access most system features.
System resources are accessed using directory numbers to dial access the resource
(station numbering, Hunt Group numbering, etc.).
Any feature or resource code may be stored for one-button access under an available
Programmable Feature Button.
Operation steps are oriented for the Executive Key Telephone since the interactive
LCD prompts encompass all Executive Key Telephone functions.
System programming can be executed at any idle Executive Key Telephone. Only one
station may enter the system programming mode at any time.
Three LCD interactive Soft Buttons are positioned beneath the display on the
Executive Key Telephone. These buttons are used during feature operation for
interactive display prompt menus. For orientation purposes, the Soft Buttons may be
referred to as the left, center and right Soft Buttons.
Valid programming is confirmed with a single beep tone from the speaker.
Invalid programming is alerted with a double beep tone.
Instructions in this chapter are predominantly the same for the DHS and the DHS-E. The
major differences concern the numbering plan:
DHS uses a 2-digit numbering plan.
DHS-E uses the 3-digit numbering plan.
Feature Access Codes are also the same; however, the exhibits in this document show
only a 2-digit Intercom number or Station number (xx). When working with DHS-E, refer
to the 3-digit numbering plan.
The following is an example of the LCD display at an idle Executive Key Telephone. The
Soft Buttons are immediately below the bottom line of the display oriented at left, center
and right positions.
OCT 1
STATION
Figure 4-1: Soft Buttons
FRI 8:00
10
4-1
Advertisement
Table of Contents
