Table of Contents
Advertisement
Call Handling Configuration
VM Dialing Ratio
There are two VM Dialing Ratio parameters that may be programmed; TONE TIME and
INT_DGT TIME.
Default
The
DHS/DHS-E
range is from 60 - 150 msec.
Related Programming
Refer to
Warning Time
Warning Time is directly related to Warning Tone and Drop Time-out. When the Warning
Time has expired, stations subject to Warning Tone and Drop Time-out will receive the
associated tone/disconnect.
Default
The
DHS/DHS-E
Related Programming
Refer to
Recall Time
Recall Time is associated to CO Line Transfer. When the Recall Time expires the CO line
will begin ringing at the station that initially transferred the call.
Default
The
DHS/DHS-E
SLT Hook Flash
Single Line Telephone operation requires that the user of a SLT hook flash to invoke call
routing features such as Hold and Call Transfer. The
of a hook flash at a SLT to distinguish a hook flash request from a hang up request. A
hook flash request is typically any depression of the hook switch lasting less than 0.8 sec
(800 msec), however users may also use the hook switch to disconnect the current call
and request dial tone for a second call.
SLT Hook Flash is divided into two programmable data fields; START and END. The START
field entry determines the minimum on-hook duration that will be accepted as a hook
flash. The END data field entry determines the maximum on-hook duration that will be
accepted as a hook flash.
TONE TIME and INT_DGT TIME are set at 120 msec, and the adjustable
"Voice Mail"
in the
System Applications
Warning Time is set for 3 minutes, and is variable from 1-8 minutes.
"Drop
Time-Out", in the
Recall Time is set for 30 sec, and is variable from 16/30/60/90/120 sec.
The system software will always maintain a hook flash time of 100 msec minimum. It is not
possible to program a hook flash time that provides no hook flash operation time.
section of this Chapter.
Station Programming
DHS/DHS-E
section of this Chapter.
must monitor the timing
6-23
Advertisement
Table of Contents
