Table of Contents
Advertisement
DHS Installation
Lock-anchors
for mounting
base
ADP Jack - When wired at the MDF, the second pair of the telephone line cord/cable
will activate this jack for any analog device function. This jack and wiring are
completely independent of the key telephone operation and may be used for system
resources. This is not FCC listed.
KSU Jack - Connect the station cable line cord here. Two pairs are provided. The first
pair is all that is required for telephone voice and data. The second pair is looped to
the ADP jack for use of analog devices at the desktop.
8. Installing a DSS Unit
To install a DSS to the System:
1. Connect the DSS to a KSU Station port. The DSS takes the place of a Station in the
system configuration.
2. Press [FEAT],#,✳ , then enter the correct password and press Show from a Display
Keyset to enter the Programming Mode.
3. Press Next using the soft buttons below the display screen until Station displays.
4. Press Show, and enter the DSS Station Number to be programmed.
KSU
Jack
Rubber Skid-stops
Figure 2-23: Key Telephone Modular Jack Locations
ADP
Jack
Hinge-anchors
for mounting
2-43
base
Advertisement
Table of Contents
