Table of Contents
Advertisement
Dial Pulse to DTMF Conversion
conference. To establish an Unsupervised conference, you must first build a Supervised
conference.
Operation
1. Two CO lines are conferenced (F+[6]+[0]) at your station:
2. Press [FEAT].
3. Dial [7] + [7]. At an Executive Telephone, the following display will be seen
momentarily.
4. If no further action is taken, the display returns to idle status. At this time, the two
lines are conferenced.
To rejoin the unsupervised conference:
1. At your station, press [FEAT].
2. Dial [6] + [0].
Conditions
New conference parties may only be added when the conference controller is a
member of the conference.
If an outside line hangs up, the line will be released.
Dial Pulse to DTMF Conversion
Description
When a CO line is set to pulse (rotary) dialing, the digits following [✳] will be sent in DTMF
tone mode. Pulse-to-tone change-over can be programmed into any Speed Dial bin, if
desired (Refer to
Unsupervised Conference requires the Option Module for operation on the DHS system.
L Nx L Nx
private
UN SUPE R VIS ED
Chapter 6, System
fo rced
C N F
Programming,
Table 6-1: Database Programming
4-41
Table).
Advertisement
Table of Contents
