Table of Contents
Advertisement
6-16
Drop Time-Out
Similar to Warning Tone above, Drop Time-Out may be applied to any station where
outgoing call length is to be restricted. When set to Y this station will receive a warning
tone over the connected voice path when the Warning Time (refer to
Configuration) has expired, and 10 sec later the current call will be terminated.
Default
DHS/DHS-E
Related Programming
Refer to
Station Position
Station numbering can be changed for any Station Port between the system allowable
range. If the current assigned station number is not desired or must be changed, the
programmer may select any of the available station directory numbers to reassign this
port.
Default
For DHS ports (1-24) the B1 channel is 10-33, and the B2 channel is 58-81. For DHS-E ports
(1-48) the B1 channel is 100-147, and the B2 channel is 148-195. The DHS range is from
10-81, and the DHS-E range is from 100-195.
Voice Mail Port
Single Line Telephone ports that are to be used for connection to a Voice Mail system
must be assigned type VM to provide longer DTMF tones. This identifies the port to the
system software for special handling.
Default
DHS/DHS-E
DSS Owner
When programming a DSS owner, enter programming mode for the station where the
DSS console resides. Then specify the key telephone station that will serve as its owner.
Default
The DHS station range is from 10-81, and the DHS-E station range is from 100-195.
Drop Time-Out is set to N (NO) for all stations.
"Warning Time"
in the
Single Line Telephone ports are set to N (NO), not assigned as a VM port.
Call Handling Configuration
Station Programming
Call Handling
section of this Chapter.
Advertisement
Table of Contents
