Event Trace Mode; Trace Mode Status - Vodavi Starplus Triad-S Installation Manual

4-16
Chapter 4 - Maintenance and Troubleshooting

Event Trace Mode

The T command enables and disables the
trace mode is enabled events for the trace desired displays on the monitor, printer or PC
connected to the
[t] and press <Return> at the mon> prompt, the following screen displays:
1. To enable an Event Trace, type t<space> (space bar).
2. Indicate type of trace desired [d], where d is determined as follows:
3. Enter the specific board, CO line or Station number of the trace desired, or type all when
all boards, CO lines or Stations events are desired.
001-012
100-131
All = All Boards, CO lines or Stations
STARPLUS Triad-S™
Figure 4-6: Trace Mode Status
B = Board event trace (traces events associated with PCB)
M = Miscellaneous State event trace
P = Pulse Coded Modulation (PCM) traces events associated with voice
communications
C = CO Line (LCOB) States (traces events associated with CO Line activity)
S = Station (STA) States (traces events associated with Station activity)
E = Error Messages (traces error messages)
Q = Queue (QUE) Events (traces queuing events: DTMF receiver, UCD, LCR, etc.)
D = Device Command (traces commands to peripheral devices)
= CO Line port
= Station location
STARPLUS Triad-S™
System. To view the current status of the trace mode type
Remote System Monitor
System Trace mode. While the