Table of Contents
Advertisement
Station Programming
Station Programming
If the system is in the programming mode, continue using the [back] and [next] Soft
Buttons to scroll to the desired programming field. If starting to program here, enter the
programming mode.
Refer to
the complete list of programmable features and their default values.
System Type
The system may be programmed for compliance to the appropriate CO line access
functionality corresponding to the FCC registration number provided to the servicing
telephone company. When the MF registration number is used, CO lines may be accessed
by any system means (direct CO line button access or Pooled CO line access). This type of
operation is referred to as PBX operation. When the KF registration number is used, CO
lines may only be accessed by a direct button assignment. That is, no Pooled CO line
access function will operate when this mode is selected. Single Line Telephones must use
specific CO line access codes when dialing out. This type of operation is referred to as KEY
operation. Local tariffs vary from one vendor to another, specific rules concerning CO
Line access should be derived from the serving telephone company. Check with your
telephone company provider for more details.
Default
The
DHS/DHS-E
Station Parameters
When the SHOW STATION prompt is displayed, the programmer should enter the two-
digit or three-digit Station number on the dial pad. Once entered, the center Soft Button
[show] is pressed to enter into Station Programming Parameters for that station number.
Default
The
DHS
Day Class of Service (COS)
Each station may be assigned one Class Of Service (COS) for the Day system mode of
operation. This COS is directly referenced in the Restriction, CO Line Call Discrimination,
Digit Interval Table programming. COS also dictates which stations will be given the
privilege of Overriding DND and joining an existing CO line conversation via the Privacy
"Program Mode Entry".
The moment the [chg] button is pressed and the value displayed, that operation becomes
functional. This is true for any field where the [chg] button selects from the available data
field values. In other areas of programming where data is entered from the dial key pad, the
[save] Soft Button must be pressed to save that entered data.
System Type is set for KEY, and can be toggled from KEY/PBX.
station range is from 10-81, and the
Also refer to
Table 6-1: Database Programming Table
DHS-E
station range is from 100-195.
6-13
for
Advertisement
Table of Contents
