Table of Contents
Advertisement
4-48
Drop Time-Out
Description
This feature is enabled in the system programming on a per station basis. When enabled,
any outgoing CO line will be automatically timed and then dropped, after the system
Warning Tone Timed is exceeded. This feature is normally used to control outgoing call
traffic.
Operation
If the Warning Time is set at 3 minutes and station x is set to Drop Time-out = Y, the active
CO line call will continue as usual until 3 minutes of conversation has elapsed.
1. The display will then change to:
2. The display will then return back to idle.
Conditions
The time limit of Drop Time-Out is closely associated with Warning Tone Time
programming. If the station Warning Tone Time is set for 5 minutes and the Drop
Time-Out feature is enabled, after 5 minutes have expired, the outgoing CO line call in
progress will be released automatically; a double beep also is heard.
If Drop Time-Out is enabled, only outgoing CO line calls at that station are affected.
No Drop Time-Out is enabled.
DSS Console <FP3>
Description
One DSS console may be assigned to a station. Each DSS Console uses one digital station
port. Up to 24 DSS consoles may be installed on a system. The DSS console buttons are
programmed by the station user using the FEAT + # + 5 command, then pressing the
button on the DSS to be programmed. All system feature codes may be stored on the
Programmable Feature Buttons for one-button operation. Certain programmed feature
buttons will light when activated (DND, Call Forward, DSS/BLF, etc.), while others such as
Call Pick-Up, Background Music, Last Number Redial, do not.
Features are separated into three distinct categories for programming on a button: CO
line, station, or feature.
CO L IN E 2
0 3 : 0 0
CO L IN E DR OP PED
Drop Time-Out
Advertisement
Table of Contents
