Table of Contents
Advertisement
4-96
Conditions
Ring transfer recall time for any CO line call is programmable, between 16, 30, 60, 90,
and 120 seconds.
When a transferred CO line recalls, the line number and station number where the
call was transferred will be displayed.
Once the outside line changes from Hold to Transfer status, the outside party will
hear Music-on-Hold change to a system-provided Ring Back tone.
Intercom calls that are transferred, follow the Intercom Selection mode at the
destination station (Voice Announce Hands-Free/Private or Tone Ring).
In screened transfer, if the person that you transferred the call to answers your
intercom call in Voice Announce Hands-Free mode, and does not go off-hook to
connect with you on an intercom channel, the CO line will transfer ring when the
transfer is completed.
With voice mail transfers, if no VM mailbox digits are entered for transfers, no digits
are sent to the VM system.
If VM mailbox digits are entered for transfers to voice mail, the following digits are
sent: XFR prefix, VM mailbox and XFR suffix.
User Name Programming
Description
An alphanumeric, seven-character user name may be assigned to each station in the
system. This name will be displayed on Executive Key Telephones in place of the standard
STATION message. Station user names are entered in system programming. The names
may consist of upper and lower case letters.
User Saved Number Redial (USNR)
Description
When on a CO Call, the user can enter the User Saved Number Redial (USNR) feature
code, allowing the entry of any other number (telephone number, FAX number, or even
bank account number), as a scratch pad entry for future use. When the station is idle, the
user can enter either the SDN ([feat] + [5] + [1]) and/or USNR feature codes to make a CO
call and dial the number stored.
Operation
To store a USNR number while on a call:
1. Press [FEAT].
2. Dial [5] + [✳]. At an Executive Key Telephone, the display shows:
SAVE U SN R N U M
User Name Programming
Advertisement
Table of Contents
