Table of Contents
Advertisement
3-30
The SMDR port baud rate is programmable from 110 to 19,200 BPS. Data Format is: 8 data
bits, 1 stop bit, No parity bit. Connection of the SMDR serial port to a computer for call
accounting is usually quite simple, since a straight-through cable will typically mate the
devices.
10. Connecting and Programming Caller ID
When Incoming Caller ID is to be used with the
The caller ID box must be connected to the
using the SP7081-00 Cable. The caller ID box collects data at each CO line to be used for
Incoming Caller ID and passes the data to the
Port on the
database programming. The caller ID box supports eight CO Lines. The CO Line
programming parameter ICLID PORT# has been added to the
programming to facilitate this need. An example of this programming is. assume a CO
line is connected to the CO position 1 and to the caller ID box line position 1.
The caller ID box is connected to the
the Main Processor Board. Consequently, the PC Programming port cannot then be used
for PC-based remote programming and Incoming Caller ID data collection
simultaneously. When all hardware connections are complete, adjust the caller ID box
option switches for 1200 BPS operation. Program the
port for 1200 BPS operation.
When installing Caller ID, the cable that connects from the KSU to the caller ID box must
be a standard null modem cable (DB9 male to DB9 male).
Table 3-14: RS-232C DB-9 Connector
Male
DCE
DB-9
K
S
U
DHS-E
must be programmed for the associated caller ID box port in customer
Designation
1
DCD
2
RX
3
TX
4
DTR
5
GND
6
DSR
7
RTS
8
CTS
9
RI
DHS-E
it is necessary to use a caller ID box.
DHS-E
system ICLID/PC Programming port
DHS-E
system for processing. Each CO Line
DHS-E
system via the ICLID/PC Programming port on
DHS-E
DHS-E Installation
DHS-E
database
system PC Programming
Advertisement
Table of Contents
