Event Trace Mode - Vodavi Starplus Triad-S Installation Manual

4-20

Event Trace Mode

The T command enables and disables the
mode. While the trace mode is enabled events for the trace desired
displays on the monitor, printer or PC connected to the
System. To view the current status of the trace mode type [t] and press
<Return> at the mon> prompt, the following screen displays:
1. To enable an Event Trace, type t<space> (space bar).
2. Indicate type of trace desired [d], where d is determined as follows:
Figure 4-6: Trace Mode Status
B = Board event trace (traces events associated with PCB)
M = Miscellaneous State event trace
P = Pulse Coded Modulation (PCM) traces events associated with
voice communications
C = CO Line (LCOB) States (traces events associated with CO Line
activity)
Remote System Monitor
STARPLUS Triad-S
STARPLUS
System Trace
Triad-S