Field Service Ver.2.0 Jan. 2007
6.3.18
Removing/reinstalling the trays 1 and 2
Note
• The trays 1 and 2 are of the same form and of the same mechanism. The procedure given here
shows mainly the operations employed for the tray 1.
• When there remains paper in the tray, be sure to remove it thoroughly before starting operations.
A. Procedure
[1]
[4] [5]
[3]
[2]
Confidential – for internal use only, do not distribute
1.
Pull out the tray 1 [1].
2.
Remove the screw [2] and then remove the stop-
per [3].
[6]
Note
• When installing the stopper, be sure to set the
positioning hole [4] to the projection [5].
3.
While holding down the stopper [6], pull out the
tray 1 for removal.
Note
• When installing the tray 1, be sure to check to
see if the tray can be pulled out and pushed in
smoothly.
• When installing the tray 1, be sure to check to
see if the tray is not thoroughly pulled out.
50gaf2c141na
6. OTHERS
163