Konica Minolta bizhub 500 Service Manual page 142

Field Service Ver.2.0 Jan. 2007
(2) ISW transfer standby
Open the Service mode of the main body to put the ISW transfer in the standby condition.
Step
1 Enter the Service mode.
2 Press the [System 2] in "Service mode screen."
3 Press the [ISW] in the sub menu shown to the right of the screen.
4 "Board Type Selection screen"
5 Press the key corresponding to the firmware to be rewritten.
e.g.: MFP controller
"ISW Execution Check MFP Controller screen"
6 Press the [Yes] in "Execution Check screen".
7 Press the Start key.
Confidential – for internal use only, do not distribute
Operation
5. FIRMWARE VERSION UP
109