Konica Minolta bizhub 500 Service Manual page 291

10. SERVICE MODE
(2) Date & Time Setting
Functions • To set the data and time-of-day
Use • Use to set or change the date and time-of-day.
1.
Setting/ Call the Service Mode to the screen.
2.
Procedure Touch [CS Remote Care].
3.
Touch [Detail Setting] to access Date & Time Setting.
4.
Enter the date (month, day and year), time-of-day, and the time zone from the 10-Key
Pad.
5.
Touch [SET] to start the clock.
(3) RAM Clear
Functions • To clear the following data at the Center
ID Code, Primary Setting, Date/Time Input (Time Zone), Software SW Setting and AT
Command.
Use • To be used for setting CS Remote Care.
• To be used for reset the every data of the Center to default.
NOTE
• If RAM Clear is selected during transmission, RAM clear processing will be
implemented at the time the transmission is completed regardless of whether it
is done properly or not.
Setting/ • The default setting is "Unset."
Procedure
(4) Communication Log Print
Functions • To print out the Communication Log.
Use • Use to output and use the Communication Log.
1.
Setting/ Call the Service Mode on the screen.
2.
Procedure Touch [CS Remote Care].
3. Touch [Detail Setting] to access [Communication Log Print].
4.
Load Tray 1 or Bypass Tray with A4S or 8
5.
Press Start key to print out the Communication Log.
(5) Software Switch Setting
Functions • To change the CS Remote Care settings.
Use • To change the settings for CS Remote Care as necessary.
Setting/ For procedures on settings, see
Procedure (See P.251)
258
Set "Unset"
"10.11.3 Software SW setting for CS Remote
Confidential – for internal use only, do not distribute
Field Service Ver.2.0 Jan. 2007
/ x 11 paper.
1
2
Care".