Punch Resist Loop (Pu) - Konica Minolta bizhub 500 Service Manual

Field Service Ver.2.0 Jan. 2007
10.9.4

Punch Resist Loop (PU)

Adjusts the registration loop amount while in the punch by PU-501.
This adjustment is made when there occurs a tilt with the punch hole, or when a jam occurs frequently in the
punch mode.
A. Procedure
1.
"Service Mode screen"
Press [Finisher].
2.
"Finisher Adjustment screen"
Press [Punch Resist Loop].
3.
"Punch Resist Loop screen"
Press [Test Copy].
4.
With the original set to DF, select a suitable paper size and press the Start key.
5.
Press [END].
6.
Check the punch holes to see if they are parallel
with the paper edge. And also check to see if a
jam occurs.
7.
"Punch Resist Loop screen"
Enter a value through the [+]/[–] or numeric keys and press [Setting].
Setting range: – 4 (longer) to + 4 mm (shorter)
1 step = 1 mm
Press [Restore] to return to the value before change.
NOTE
• When a jam occurs in the punch mode, set a value to the minus (–) side.
• When the line of punch holes is slanted, set a value to the plus (+) side.
8. Repeat steps 3 to 7 until it gets inside the standard value.
9.
Press [OK].
Confidential – for internal use only, do not distribute
10. SERVICE MODE
4512f3c004na
245