Image Position: Side Edge (Scan Area) - Konica Minolta bizhub 500 Service Manual

10. SERVICE MODE
10.3.7

Image Position: Side Edge (Scan Area)

Adjusts the mis-centering of the image in the main scan direction while in the scan in the platen mode.
Note
• Be sure that the adjustment of the Print Position: Side Edge has been completed.
(See P.180)
A. Procedure
1. "Service Mode screen"
Press [Machine].
2.
"Machine Adjust screen"
Press [Scan Area].
3.
"Scan Area screen"
Press [Image Position: Side Edge].
4.
"Scan Area (Image Position: Side Edge) screen"
Press [Test Copy].
5.
"Test Copy screen"
With the test chart set on the original glass, select A3 (for metric) or 11 x 17 (for inch) paper and press the
Start key.
6. Press [OK].
7.
Fold the output paper into two at the center in the main scan direction and check it for discrepancy
against the center line of the print.
Standard value: 0 ± 1.5 mm or less
8. "Scan Area screen"
Enter a value through the [+]/[–] or numeric keys and press [Setting].
Setting range: – 2.96 (image: to the rear) to + 2.96 mm (image: to the front)
1 step = 0.04 mm
Press [Restore] to return to a value before change.
9.
Repeat steps 4 to 8 until it gets within the standard value.
10.
Press [END].
186
Confidential – for internal use only, do not distribute
Field Service Ver.2.0 Jan. 2007