Konica Minolta bizhub 500 Service Manual page 348

Field Service Ver.2.0 Jan. 2007
Classification Jam code
DF J-6607
J-6608
FS-510 J-7201
FS-511
FS-510 J-7202
FS-511
FS-510 J-7203
SD J-7204
MT J-7205
FS-510 J-7216
FS-511
Confidential – for internal use only, do not distribute
Cause
When feeding the second original in
the mode other than the single sided
mode, the original exit sensor (PS10)
does not turn OFF within a specified
period of time after the PS10 turns
ON.
When feeding the third original in the
mode other than the single sided
mode, the original exit sensor (PS10)
does not turn OFF within a specified
period of time after the PS10 turns
ON.
While in the idle, the entrance sensor
(PS4) is ON.
While in the idle, the passage sensor
(PS2) of RU turns ON.
While in the idle, the conveyance sen-
sor (PS5) or the stacker sensor (PS8)
is ON.
While in the idle, any of the sub tray
exit sensor (PS1), the bypass route
conveyance sensor (PS2), the inter-
mediate conveyance sensor (PS3),
the main route conveyance sensor
(PS4) or the alignment tray sensor
(PS5) is ON.
While in the idle, the stacker sensor
(PS8) is ON.
While in the idle, the the paper exit
sensor (PS20) is ON.
While in the idle, the conveyance sen-
sor /Up (PS9) or /Lw (PS10) is ON.
The entrance sensor (PS4) of FS does
not turn ON within a specified period
of time after the fusing exit sensor
(PS3) of the main body turns ON.
The path sensor (PS2) of RU does not
turn ON within a specified period of
time after the fusing exit sensor (PS3)
of the main body turns ON.
Resulting Correction
operation
The DF stops Open the open/close
immediately. If cover and remove
there is paper jammed paper if any.
being trans-
ferred or having
been trans-
ferred, the main
body completes
the paper exit
before stopping
operations.
FS, RU, MT, SD, Remove jammed paper
main body stop if any from the FS/main
immediately. body.
12. JAM CODE
315