Figure 78: Displaying Egress Port Schedulers - LevelOne GEL-2670 User Manual

Weight – A weight assigned to each of the queues (and thereby to
■
the corresponding traffic priorities). This weight sets the frequency
at which each queue is polled for service, and subsequently affects
the response time for software applications assigned a specific
priority value. (Range: 1-100; Default: 17)
Percent – The weight as a percentage for this queue.
■
Port Shaper – Sets the rate at which traffic can egress this queue.
◆
Enable – Enables or disables port shaping. (Default: Disabled)
■
Rate – Controls the rate for the port shaper. The default value is
■
500. This value is restricted to 100-1000000 kbps, or 1-3300 Mbps
Unit – Controls the unit of measure for the port shaper rate as
■
"kbps" or "Mbps." (Default: kbps)
W I
EB NTERFACE
To show an overview of the queue mode and weight used by egress ports:
Click Configuration, QoS, Port Scheduler.
1.
Click on any enter under the Port field to configure the Port Scheduler
2.
and Shaper.

Figure 78: Displaying Egress Port Schedulers

– 197 –
| Configuring the Switch
C 4
HAPTER
Quality of Service