Table of Contents
Advertisement
Chapter 4.
By reading this chapter, you can understand the basic network parameters required for the device
to access to the Internet, and these parameters are configured to connect the device to the Internet.
Before configuring "Internet Line" in the Configuration Wizard, you should properly configure the
network settings of the network computer. For specific methods, see Chapter 3 Logging in the
Device.
If this is the first time for you to log in the device, a configuration wizard homepage appears
directly in the main operating page. As shown in Figure 4_1:
In logging next time, the wizard will no longer automatically pop up: When checking it, you
can go directly to the System Status page in logging next time;
Exit the wizard: Exits the Configuration Wizard and returns to the System Status page.
Next step: Enter the Selection of device access mode page
4.1
WAN1 Port Configuration - Dynamic IP access
Configure the second page of the wizard to configure the WAN1 port address of the device. The
default WAN line access takes dynamic IP access, as shown in Figure 4-2. If your Internet access
mode is dynamic IP access, please click <Finish>, to complete the configuration of the Internet
line.
http://www.level1.com
Configuration Wizard
Figure 4_1 Home page of configuration wizard
Chapter 4 Configuration Wizard
.
Page 12
Advertisement
Table of Contents
