LevelOne GEL-2670 User Manual page 182

| Configuring the Switch
C 4
HAPTER
Configuring MAC-based VLANs
C U
OMMAND SAGE
Source MAC addresses can be mapped to only one VLAN ID.
◆
Configured MAC addresses cannot be broadcast or multicast addresses.
◆
When MAC-based and protocol-based VLANs are both enabled, priority
◆
is applied in this sequence, and then port-based VLANs last.
P
ARAMETERS
These parameters are displayed:
MAC Address – A source MAC address which is to be mapped to a
◆
specific VLAN. The MAC address must be specified in the format xx-xx-
xx-xx-xx-xx.
VLAN ID – VLAN to which ingress traffic matching the specified source
◆
MAC address is forwarded. (Range: 1-4093)
◆ Port Members – The ports assigned to this VLAN.
W I
EB NTERFACE
To map a MAC address to a VLAN:
Click Configuration, VCL, MAC-based VLANs.
1.
Enter an address in the MAC Address field.
2.
Enter an identifier in the VLAN field. Note that the specified VLAN need
3.
not already be configured.
Specify the ports assigned to this VLAN.
4.
Click Save.
5.
Figure 69: Configuring MAC-Based VLANs
– 182 –