Figure 77: Configuring Ingress Port Policing - LevelOne GEL-2670 User Manual

Enabled – Enables or disables port policing on a port.
◆
Rate – Controls the maximum rate for frames entering the ingress
◆
queue for a port. (Range: 100-1,000,000 kbps/fps, 1-3.300 Mbps/kfps;
Default: 500 for all units of measure)
Unit – Controls the unit of measure for the policer rate as kbps, Mbps,
◆
fps or kfps. The default value is kbps.
Flow Control – If flow control is enabled and the port is in flow control
◆
mode, then pause frames are sent instead of discarding frames.
W I
EB NTERFACE
To configure ingress port policing:
Click Advanced Configuration, QoS, Port Policing.
1.
Enable port policing as required for any port, set the maximum ingress
2.
rate and unit of measure, and then enable flow control if required.
Click Save.
3.

Figure 77: Configuring Ingress Port Policing

– 195 –
| Configuring the Switch
C 4
HAPTER
Quality of Service